Bush DW12-TFE3, Руководство по обслуживанию

Страница: 9 / 50

Page 8 of 49
Service Manual
Model No: DW12-TFE3 Series
Issue
Rev.
make sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk
that the water inlet can get blocked and damage the appliance.
1-5-7. Hot Water Connection
The water supply to the appliance can also be connected to the house's hot water line (centralised
system, heating system), as long as it does not exceed a temperature of 60
℃
.
In this case, the wash cycle time will be shortened by about 15 minutes and the wash efficiency
slightly reduced.
The connection must be made to the hot water line following the same procedures as those for the
connection to the cold water line.
Attention:
The special plastic hose support must be solidly fastened to the wall to prevent the drain hose from
moving and allowing water to spill outside the drain.
Warning
The appliance is to be connected to the water mains using new hose-sets and that old
hose-sets should not be reused.
1-5-8. Electrical Connection
After making sure that the voltage and frequency values for the current in the home correspond to
those on the rating plate (located on the stainless steel inner door of the appliance) and that the
electrical system is correct for the maximum voltage on the rating plate, insert the plug into an
electrical socket which is earthed properly (the earthing of the appliance is a safety requirement
mandated by law).
If the electrical socket to which the appliance must be connected is not appropriate for the plug,
replace the whole cable, rather than using adaptors or the like as they could cause overheating and
burns.
Caution:
The dishwasher plug must be accessible even when the appliance is installed as a built-in
unit so that maintenance can be done safely.