Bush DW12-TFE3, Руководство по обслуживанию

Страница: 26 / 50

Page 25 of 49
Service Manual
Model No: DW12-TFE3 Series
Issue
Rev.
1-10. How to fill rinse aid and detergent dispenser
1-10-1. How to fill rinse aid
1-10-1-1.Rinse aid
This product makes dishes sparkle and helps them to dry without spotting.
The dispenser is located on the inside panel of the door.
1-10-1-2.Loading the rinse aid
Regardless of the type of detergent dispenser installed on your
appliance, you must proceed as indicated below when loading the
rinse aid.
To open the dispenser, turn the "1" cap in an anti-clockwise direction
and then pour in the rinse aid, making sure not to overfill. The
amount of rinse aid used for each cycle can be regulated by turning
the " 2" dose adjuster, located beneath the "1" cap, with a
screwdriver.
There are 6 different settings; the normal dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or
spotting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have
white streaks, turn the dosage adjustor to a lower setting.
1-10-2. How to fill detergent dispenser
1-10
-2-1.Detergent
Detergent specifically intended for use with dishwashers must be
used. The dispenser must be refilled before the start of each wash
cycle following the instructions provided in the " Wash Cycle Table
". The detergent dispenser is located on the inside panel of the
door.
1-10 -2-2.Loading the detergent
To open the " 3 " cover on the dispenser, press the " 4 " button.
The detergent for the wash cycle should be poured into the " 5 "
compartment.
The detergent for the pre-wash cycle should be poured into the “ 6 ”
compartment.
After the detergent has been placed in the dispenser, close the
cover and press down until it clicks in place.
Notice:
To facilitate closing the cover, remove any excess detergent on the edges of the dispenser.