Bush DLED43287FHDDVD, Инструкция по эксплуатации

Страница: 26 / 48

Event Options
Use the directional buttons to highlight an event and press
OK button to display Event Options menu. The following
options are available.
Select Channel:
Using this option, you can switch to the
selected channel.
Set Timer on Event / Delete Timer on Event: After you
have selected an event in the EPG menu, press the OK
button. Select Set Timer on Event option and press the
OK
button. You can set a timer for future events. To cancel
an already set timer, highlight that event and press the OK
button. Then select
Delete Timer on Event option. The
timer will be cancelled.
Notes:
You cannot switch to any other channel or source
while there is an active timer on the current channel.
It is not possible to set timer for two or more individual
events at the same time interval.
Teletext Services
Press the Text button to enter. Press again to activate
mix mode, which allows you to see the teletext page
and the TV broadcast at the same time. Press once more
to exit. If available, sections in the teletext pages will
become colour-coded and can be selected by pressing
the coloured buttons. Follow the instructions displayed
on the screen.
Digital Teletext
Press the Text button to view digital teletext information.
Operate it with the coloured buttons, cursor buttons
and the
OK
button. The operation method may differ
depending on the contents of the digital teletext. Follow
the instructions displayed on the digital teletext screen.
When the
Text
button is pressed again, the TV returns to
television broadcast.Software Upgrade
Your TV is capable of finding and updating the firmware
automatically via the broadcast signal.
Software upgrade search via user interface
On the main menu select
System>Settings
and then
More . Navigate to Software upgrade and press the
OK button. In Upgrade options menu select Scan for
upgrade and press OK button to check for a new software
upgrade.
If a new upgrade is found, it starts to download
the upgrade. After the download is completed
confirm the question asking about rebooting the
TV by pressing the
OK
to continue with the reboot
operation.
3 AM search and upgrade mode
Your TV will search for new upgrades at 3:00 o’clock if
Automatic scanning option in the Upgrade options
menu is set to Enabled and if the TV is connected to an
aerial signal. If a new software is found and downloaded
successfully, it will be installed at the next power on.
Note: Do not unplug the power cord while led is blinking
during the reboot process. If the TV fails to come on after
the upgrade, unplug, wait for two minutes then plug it
back in.
Advanced features
Getting the most from your TV
Advanced features 24
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,