Page 5
Further adjustments
1:
Raise the stylus protector towards the front of the
cartridge .
2:
Remove the cable tie securing the tone arm and
keep safe for use when transporting or adjusting the
turntable .
3:
Set the speed selector
(9)
to the required speed
33
,
78
or
45
rpm .
4:
Select the the size of the record you wish to play using
the
SIZE SELCT
control
(11)
. Choose from
17
cm
(7”)
or
30
cm
(12”)
.
Mains connection
1:
Connect the mains plug to a wall outlet .
2:
Press the
ON/OFF
power button
(4)
to power the
turntable on . The strobe illuminator
(7)
will light up to
indicate the unit is
ON .
NOTE: Please ensure this connection is made
after the output connections.
NOTE: This unit is designed to enter STANDBY
mode automatically after 20 MINUTES
(approximately) of inactivity.
Press the POWER button twice to resume use.
Buttons and functions
Play button
1:
Press to begin playback . The tone arm will lift from the
rest and locate itself on the outer edge of the record .
NOTE: it is important to set the size of the record
correctly using the SIZE SELECT control (11)
first to ensure the stylus is located in the correct
position.
Eject button
1:
Press to stop playback and return the tone arm back
to the rest position .
Cue button
1:
Pressing this button inwards lifts the tone arm above
the rest position so the tone arm can be located
anywhere above the record .
2:
Pressing the button once more lowers the tone arm
allowing the stylus to gently contact the record and
begin playback from the custom location .
Pitch adjust
Follow the below steps to ensure the platter speed is
revolving at the correct speed .
1:
During playback of a record observe the strobe
calibration dots on the platter .
2:
The upper set of dots relate to the
33
rpm setting the
mid set of dots relate to the
45
rpm setting and the
lower set relate to the
78
rpm setting .
3:
If the strobe dots appear to be flowing to the right, the
platter is moving slower than the rated speed and you
should increase the pitch adjust
(10)
(slide the knob
upwards)
.
4:
If the strobe dots appear to be flowing to the left, the
platter is moving faster than the rated speed and you
should decrease the pitch adjust
(10)
(slide the knob
downwards)
.
5:
Keep adjusting the pitch adjust until the strobe dots
do not flow left or right and stay stationary .
User instructions
Содержание CTT939
Страница 1: ...Instruction Manual CTT939 ...
