Page 4
Preperation for use
Remote control battery installation
1:
Remove the battery cover
(as shown)
.
2:
Insert
2
x
AAA
batteries
(supplied)
, taking note that
the polarities match up .
3:
Replace the battery cover, in the same manner as you
removed it .
1
2
3
Notes on battery usage
• Do not insert battery into the remote control in the
wrong direction .
• Do not charge, heat, open or short-circuit the battery .
Do not throw battery into a fire .
• If the remote control does not function correctly or
if the operating range becomes reduced, replace all
batteries with new ones .
• Improper replacement of batteries may result
in explosive hazard . It must be replaced only by
batteries with the same or equivalent type .
Connecting the loud speakers
RIGHT SPEAKER
LEFT SPEAKER
REAR PANEL
1:
Unwrap the speaker wires .
2:
Place a speaker on either side of the main unit,
preferably at the same height, and with at least
150
mm between each speaker and the main unit .
3
: Connect the speaker wires to the terminals on the
rear of the unit
(15)
. Take care to match the speaker
placed to the
LEFT
to the
LEFT
output on the rear of
the unit . Repeat for the
RIGHT
speaker .
Connecting the loud speakers (cont)
4:
When connecting ensure the
RED
wire connects to
the
RED
terminal and the
BLACK
wire to the
BLACK
terminal .
Connecting the mains power
1:
Connect the mains plug to a
UK
wall outlet .
2:
Extend the pig tail antenna as far as it can go .
NOTE: The quality of the DAB/FM reception will be
influenced
by the positioning of the pigtail aerial .
3:
Press the
STANDBY
button
(2
,
17)
to wake from
standby .
Standby mode
1:
Press the
STANDBY
button on the unit
(2)
or press the
STANDBY
button
(17)
on the remote to put the system
into standby mode . To resume normal operation press
either button again .
NOTE: This unit is designed to enter STANDBY
mode automatically after 20 MINUTES
(approximately) of inactivity. Press the STANDBY
button to wake the unit.
NOTE: When you power on the unit from standby
the last used mode will resume.
General operation
Volume controls
1:
Rotate the
VOLUME
control
(10)
clockwise or press
the
button
(26)
to increase the volume
level .
2:
Rotate the
VOLUME
control
(10)
anti-clockwise or
press the
VOLUME-
button
(26)
to decrease the
volume level .
Mute function
1:
Press the
MUTE
button
(27)
at any time to silence the
output .
2:
Press again to resume audio output .
Installation
