Page 7
EQ modes
You can change the EQ levels to adapt to the type of
audio you are listening to.
1:
Press the
EQ
button
(27)
repeatedly to cycle through
the available options of:
FLAT
,
ROCK
,
CLASSIC
,
POP
&
JAZZ.
Bluetooth connection
Follow the below steps to pair your device with the
CMC1112BT .
1:
Make sure you are in
BT
mode, if not press the
SOURCE
button
(4
,
33)
until you reach
‘bt’
.
2:
When selected the
‘bt’
text on the display will flash
while the unit tries to connect to previously paired
devices . If no devices are found the
‘bt’
text will
continue to flash to indicate it is ready for pairing a
new device .
3:
Enable the Bluetooth function on your audio device
and search for a device labelled
‘CMC1112BT’
in
the available list . The maximum distance for pairing
devices is
1
metre .
4:
Select and enable pairing for the
‘CMC1112BT’
device . If prompted for a password enter
‘0000’
.
5:
If pairing is successful the micro system will beep and
the
‘bt’
text will stop flashing .
6:
If the connected device goes out of range, the micro
system will attempt to connect for
2
minutes . When
the device comes into range the unit will reconnect
again automatically .
7:
To remove a paired device press and hold the
STOP/
PAIR
button
(32)
on the remote control . The
‘bt’
text
will begin flashing again to indicate pairing mode .
Controlling a paired device
Once connected you can either use the controls on
the audio device to begin playback, skip tracks etc .
Or you can use the control buttons on the unit & remote .
1:
The
PLAY/PAUSE
button
(10
,
21)
when pressed will
begin playback of the selected track on the audio
device . Press again to pause playback .
2:
To skip to the next track press the
SKIP
button
(13
,
22)
.
3:
To skip to the previous track press the
SKIP
button
(12
,
22)
.
4:
Any further operations must be done from the audio
device .
Controlling a paired device (cont)
NOTE: the volume output is effected by the
volume level on the audio source EG: Phone or
laptop, so make sure that is set to about 70-80% (
not too loud to avoid distortion).
Bluetooth notes
• The operation range of bluetooth is approximately 10
meters (30 Feet). Any obstacles in the path between
devices may reduce this range.
• Only one Bluetooth device can be paired at a time.
• Not all Bluetooth devices are compatible.
Remote control battery replacement
• Replace the remote control battery when it no
longer operates the unit, or the range is reduced
considerably .
• Use only
CR2025
3V lithium batteries
• Bear in mind that lighting & other room conditions, in
addition to battery age, can affect the operating range
of an infrared remote control .
A
B
C
1:
Press the tab on the bottom of the remote control
inwards as shown
(A)
.
2:
Pull the battery compartment out
(B)
.
3:
Remove old battery and replace with the same type
with the + facing upwards
(C)
.
4:
Push the battery compartment back inside the
remote and close .
NOTE: Dispose of used batteries with regards to
the recycling regulations in your area.
Do NOT short circuit batteries or throw them into
water, the general rubbish or in a fire.
Weak batteries can leak and damage the remote
control. Replace them in good time.
User instructions
Содержание CMC1112BT
Страница 1: ...Instruction Manual CMC1112BT ...
