Bush BSC90DFB, Руководство пользователя

Страница: 21 / 48

Installing your combined gas cooker
Bringing it all together
Installing your Combined Gas Cooker
21
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 257 7271.
with flame failure device, the screw is located on the
side of the valve spindle. For easier reduced flame
adjustment, it is advised to remove the control panel
(and microswitch, if present) during adjustment.
To determine the minimum position, ignite the burners
and leave them on in minimum position.
Remove the with the help of a small screwdriver fasten
or loosen the bypass screw around 90 angular degrees.
When the flame has a length of at least 4mm, the gas is
well distributed. Make sure that the flame does not die
out when passing from the maximum position to the
minimum position. Create an artificial wind with your
hand toward the flame to see if the flames are stable.
:The position the bypass screw must be loosened for
conversion from LPG to NG. For conversion from NG
to LPG, the same screw must be fastened. Make sure
that the appliance is unpluged from the electric mains
and the gas supply is open.
Fig 6.
Electric Connection and Safety
During the electric connection, follow the instructions
stated in the user manual.
Fig 7.
• The earthing cable must be connected to the earth
terminal
• You have to ensure the power cord with suitable
insulation to be connected to the power source
during the connection If there is no appropriate
earthed electric outlet in accordance with
regulations in the place where the appliance to
be installed, contact to our authorized service.
The earthed electric outlet must be close to the
appliance.
• Do not use an extension cord.
• The power cord must not touch to the hot surface
of the product.
• In case the cord is damaged, contact Authorized
Service to have it changed.
• Any wrong electric connection may damage your
appliance, as well as endangering your safety,
rendering your guarantee invalid.
• The appliance is adjusted for 230V 50Hz electricity.
If the mains electricity is different contact your
authorized
service.
• The supply cord
should be kept away
from hot parts of the
appliance. Otherwise,
the cord may be
damaged, causing a
short circuit.
• The manufacturer