Bush BSC90DFB, Руководство пользователя

Страница: 20 / 48

Installing your combined gas cooker
Bringing it all together
Installing your Combined Gas Cooker
20
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
below can be required. In such a case, contact local
authorities to learn the correct gas connection.
Fig 3.
It is required to call the authorized service to be able to
make the gas connections appropriately and in
compliance with safety standards.
Attention : Do not use any match or lighter for control
of gas leakage.
Changing the gas inlet
For some countries, the gas inlet type can be different
for LPG/NG gases. In such a case, remove the current
connection components and nuts (if any) and connect
the new gas supply accordingly. In all conditions,
all components used in gas connections should be
approved by local and/or international authorities. In all
gas connections, refer to the “Assembly of gas supply
and leakage check” clause explained before.
Caution : The following procedures must be
undertaken by authorized service people.
Gas Conversion
Your appliance is adjusted to be operated with LPG/NG
gas. The gas burners can be adapted to different types
of gas, by replacing the corresponding injectors and
adjusting the minimum flame length, suitable to the
gas in use. For this purpose, the following steps should
be performed.
Changing injectors:
Hob Burners
• Cut off the main gas supply and unplug from the
electric mains
• Remove the burner cap and the adapter (
Fig 4
).
• Unscrew the injectors. For this, use a 7mm spanner
(
Fig 5 ).
• Replace the injector with the ones from the gas
conversion kit, with corresponding diameters
suitable to the type of gas that is going to be used,
according to the information chart (which is also
supplied in the gas conversion kit).
Fig 4.
Fig 5.
Adjusting the reduced flame position
The flame length in the minimum position is adjusted
with a flat screw located on the valve. For valves