Bush BD-618 AM/FM, Инструкция по эксплуатации

Страница: 26 / 48

Using your Bluetooth Micro System
26
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Using your Bluetooth Micro System
Let’s get started
FM Radio mode
If you are not already in FM mode, briefly press and release the Mode button on the
front of the Micro or on the remote control to go to FM mode (check the display). If you
were listening to an FM station when you switched the Micro off then this station will be
automatically selected when you switch the Micro back on.
Wire radio aerial
Please make sure that the wire aerial on the back of the Micro is fully extended and
adjusted before you attempt to tune to an FM radio station (a vertical position is
recommended). This will ensure that the maximum signal strength is available when the
Micro begins to scan. Extending the aerial also ensures the best possible sound quality.
Tuning to an FM station
In FM mode:
Press and hold the Tune+ on the front of the Micro or the button on the remote
control to scan up the frequency band, your Micro will search for the next available station
and then stop on that station.
Press and release the Tune+ on the front of the Micro or the button on the remote
control to scan up the frequency band in 0.05MHz steps
Press and hold the Tune- button on the front of the Micro or the on the remote
control to scan down the frequency band, your Micro will search for the next available
station and then stop on that station.
Press and release the Tune- button on the front of the Micro or the button on the
remote control to scan down the frequency band in 0.05MHz steps.
Note: If reception is poor check that the wire aerial is fully extended or try moving the
Micro to another location.