FAILURE
PROBABLE CAUSE
METHODS OF ELIMINATION
Too much detergent has been
used.
Press the start/pause button.In order to
stop the foam,dilute one table-spoon of
softener in half liter of water and pour it
in the detergent drawer.Press the
start/pause button after 5-10
minutes.Arrange the amount of the
detergent properly in the next washing
process.
Excessive foam in
the detergent drawer.
Wrong detergent has been used.
Use only the detergents produced for
full automatic machines.
Your laundry is too dirty for the
programme you have selected.
Select a suitable programme. (see
page 8)
The washing result is
poor.
The amount of detergent used is
not sufficient.
Use more detergent.
Clothes exceeding the maximum
capacity have been loaded in the
machine.
Put the clothes in your machine in a
manner not to exceed its maximum
capacity.
Your water may be hard.
Use the amount of detergent specified
by the detergent manufacturer.
The washing result is
not good.
Distribution of the clothes in your
machine is not well-balanced.
Spread the clothes inside the machine in
an orderly and well-balanced manner .
The water is drained
from the machine as
soon as it is filled.
The end of the water drain hose is
in a position too low according to
the machine.
Position the water drain at an
appropriate height.(**)
No water is seen in
the drum during
washing.
No failure. The water is in the
lower part of the drum.
-
There are residues of
detergent on the
clothes.
Some detergents contain
ingredients which are not soluble
in water and which may form
white stains on your clothes.
By adjusting your machine, carry out an
additional rinse, or eliminate the stains
after drying, with a brush.
There are grey stains
on the clothes.
These stains may be caused by
oil,cream or ointment .
In the next washing operation, use the
maximum detergent amount declared by
the detergent producer.
The spinning process
is not done or starts
with delay .
No failure. The unbalanced load
control may work in that way.
The unbalanced load control system will
try to distribute your clothes in a
homogenous manner. After your clothes
are distributed, passage to spining
process will be realized. In the next
washing process,place your clothes into
the machine in a well-balanced manner.
(*) See the section concerning the care and maintenance of your machine.
(**) See the section concerning installation of your machine.
16
Содержание A126Q
Страница 19: ...18...
