Bush 54152B, Инструкция по эксплуатации, Страница: 30 / 36

If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions.
30
Tips for Savıng Energy
1. Install the appliance in a cool, well-ventilated
room, but not in direct sunlight and not near
a heat source (such as a radiator or oven)
otherwise an insulating plate should be used.
2. Allow warm food and drinks to cool before
placing them inside the appliance.
3. Place thawing food in the refrigerator
compartment. The low temperature of the
frozen food will help cool the refrigerator
compartment while the food is thawing. This will
save energy. Frozen food left to thaw outside of
the appliance will result in a waste of energy.
4. Drinks or other liquids should be covered
when inside the appliance. If left uncovered,
the humidity inside the appliance will increase,
therefore the appliance uses more energy.
Keeping drinks and other liquids covered helps
preserve their smell and taste.
5. Avoid keeping the doors open for long periods
and opening the doors too frequently as warm
air will enter the appliance and cause the
compressor to switch on unnecessarily often.
6. Keep the covers of the different temperature
compartments (such as the crisper and chiller)
closed.
7. The door gasket must be clean and pliable.
Replace gaskets if worn.
8. Energy consumption of your appliance is
declared without drawers and fully loaded in
freezer compartmant.
9. For saving energy, do not use volume between
the load limit and the door, along the load
limit line. Load limit line is also used in energy
consumption declaration.
Product support
Help is always at hand
Product support
• If the problem persists after you have followed
all the instructions above, please consult the
nearest Authorised Service Centre.
• This appliance is designed for domestic use
and for the stated purposes only. It is not
suitable for commercial or common use. If
the consumer uses the appliance in a way
that does not comply with these instructions,
we emphasise that the manufacturer and the
dealer will not be responsible for any repair or
failure within the guarantee period.