Bush Hog RS2650B, Руководство оператора, Страница: 21 / 40

16
To turn to the left while backing, move the left lever forward toward neutral. To turn to the right
while backing, move the right lever forward toward neutral.
POTENTIAL HAZARD
· Machine can spin very rapidly by positioning one lever too much ahead of the other.
WHAT CAN HAPPEN
· Operator may lose control of the machine, which may cause damage to the machine or injury.
HOW TO AVOID THE HAZARD
· Use caution when making turns.
· Slow the machine down before making sharp turns.
POTENTIAL HAZARD
· When going forward, if you rapidly pull the motion control levers to the middle T-slot position
and push them out, it may cause the parking brake to lock.
WHAT CAN HAPPEN
· If the parking brake is locked, it may cause the machine not to move when trying to go forward
again or rotate at high speed.
· Operator may lose control of the machine, which may cause damage to the machine or injury.
HOW TO AVOID THE HAZARD
·To go forward, pull the motion control levers to the middle position until the machine stops, then
push the motion control levers to the parking brake position.
· When the parking brake is locked, pull the motion control levers to the reverse position slowly,
then the locked parking brake device will be released.
4.1.3 PTO Engagement Switch : Located on the front of console.
Switch must be pulled out to the " ROTATE" position to engage the blades.
Switch is pushed in to the " STOP" position to stop the blades.
4.1.4 Choke Control : Located on the front of console.
Choke is used to aid in starting a cold engine. Pull the choke switch to " "position to open, press the
choke switch to" "position to close. DO NOT run a warm engine with choke in the " "(open)
position.
4.1.5 Throttle Control : Located on the front of console.
Throttle is used to control engine speed. Moving throttle lever forward will increase engine speed and
moving throttle lever back will decrease engine speed.
4.1.6 Ignition Switch : Located on the front of console.
Ignition Switch is used to start and stop the engine. The switch has three positions "OFF", "ON", and
"START". Insert the key into switch and rotate clockwise to the "ON" position.
Rotate clockwise to the next position to engage the starter (key must be held against spring pressure in
this position) release the key when the engine starts.
Brake must be engaged, motion control levers out (neutral lock position), and PTO switch "OFF"
to start engine.
(It is not necessary for the operator to be in the seat to start the engine.)
4.1.7 Fuel Shut-Off Valve 1 : Located on the front of console.