Bush Hog RS2650B, Руководство оператора, Страница: 19 / 40

14
×
25 bolts, four 8mm flat washers, and four 8mm spring washers from the plastic bag.
b) Place the right control lever to the outside of the control arm shaft, insert the bolts into the holes with
flat washers and spring washers and tighten them. (See Figure 2)
c) Install the other side the same way.
NOTE: There are two lever height options available. Place the levers in the first and the third
hole (from the top) to increase height of the levers or in the first and the third hole (from the
bottom) to decrease the height of the levers.
d) If the levers do not align with each other, when in the neutral position, loosen the hardware and make
the appropriate adjustment by sliding the lever forward or backward until properly aligned and tighten
hardware.
FIG 2 Right Motion Control Lever Assembly
e) If the ends of the levers hit against each other while in the drive position, make adjustments by moving
the levers outward to the neutral lock position and carefully bending them outward. Move them back to
the drive position and check for clearance, repeat if necessary.
3.6 SERVICE ENGINE
Check oil level and if necessary, fill the oil in the tank to the appropriate level. (See Figure 3)
FIG 3