SAFETY
2647 01/11
Safety Section 1-12
© 2011 Alamo Group Inc.
SAFETY
Maintenance and Service Safety Instructions and Practices
Do not raise the loader on a hillside. Do not transport across a slope with
a raised loader. When the loader is raised, the center of gravity of the
tractor and loader is raised increasing the potential for the tractor to tip
over. Tractor wheel contact with any wash out, drop off or the ground
obstruction with a raised loader could result in the tractor tipping over and
causing serious bodily injury.
(SL-21)
Lower the loader to the bed of the truck or trailer when transporting the
tractor and loader with a truck. Measure to ensure the transport height
does not exceed the legal limits. Contact with overhead obstructions or
power lines can cause property damage or serious injury.
(SL-34)
In case of mechanical difficulty during operation, place the transmission in the park
position, set the parking brake, shut down all power, including the PTO and the engine and
remove the key. Wait until all rotating motion has stopped before dismounting.
(SG-39)
Transport an empty bale spear tilted back in the vertical position to
prevent unintended harm to a person, animal or object. Serious injury
or death may occur from a bale spear puncture.
(SL-39)
Never drive the power unit with the bucket or plow in the raised position.
Traveling with the bucket or plow in the raised position increases the
chances of colliding with overhead obstructions and making the unit more
prone to tipping over.
(SNPO-37)
READ, UNDERSTAND, and FOLLOW the following Safety Messages. Serious injury or
death may occur unless care is taken to follow the warnings and instructions stated in the
Safety Messages. Always use good common sense to avoid hazards.
(SG-2)
Never interfere with factory-set hydraulic calibrations. Any change in calibration could
cause a failure of the equipment and may result in injury.
(SBH-13)
Always maintain the safety signs in good readable condition. If the safety signs are missing,
damaged, or unreadable, obtain and install replacement safety signs immediately.
(SG-5)
Содержание 2647
