BUSCH MINK MM 1402 AV, Инструкция по эксплуатации

Страница: 23 / 28

Troubleshooting | 11
Instruction Manual MINK MM 1402-1502 AV_EN_en 23 / 28
IS
CPL
Problem Possible Cause Remedy
The machine does not start. The motor is not supplied
with the correct voltage.
• Check the power supply.
The motor is defective. • Replace the motor.
The coupling (CPL) is defec-
tive. • Replace the coupling
(CPL).
The machine does not reach
the usual pressure on the
suction connection. The inlet screen (IS) is par-
tially clogged. • Clean the inlet screen (IS).
The inlet filter cartridge (op-
tional) is partially clogged. • Replace the inlet filter car-
tridge.
Internal parts are worn or
damaged. • Repair the machine (con-
tact Busch).
The machine runs very noisily. Worn coupling (CPL). • Replace the coupling
(CPL).
Oil level too low. • Top up oil.
Defective bearings. • Repair the machine (con-
tact Busch).
The machine runs too hot. Insufficient cooling. • Remove dust and dirt
from the machine.
Ambient temperature too
high. • Observe the permitted
ambient temperature, see
Technical Data [ ► 24] .
Temperature of the process
gases at the inlet too high. • Observe the permitted
gas inlet temperature, see
Technical Data [ ► 24] .
Oil level too low. • Top up oil.
For the solution of problems not mentioned in the troubleshooting chart contact your
Busch representative.