19
16. Phone book
Press and release the button for the voice control shortly and use the
voice command
`PHONE BOOK
´.
Since your phonebook is scanned with the first coupling of your mobile
phone with the system, it is immediately available to you and is stored
until you delete the mobile phone from the list (see chapter:
Bluetooth
®
). The telephone book data can of course only be seen or
changed by you. After the first entry has automatically been read aloud,
in addition to the standard commands the following voice commands
are available:
The marked entry is read aloud again.
The entire list is read aloud to you.
With
`STOP
´ you can stop the process and select the respective
entry.
You are able to navigate in the list using the commands “
NEXT
” or
“
PREVIOUS
”.
Start your telephone call with the command “
DIAL”
.
`
JOE BLOGGS´
is a placeholder for an entry from your phonebook. If
you select a name, you go directly to the respective entry.
Note:
It is important that the stated name exactly corresponds
with the recorded entry in the phonebook.
Please note that telephone book entries, which are only
shown in capital letters must be spelt out.
Depending on the type of mobile phone, it is possible that
the order of the first names and surnames may have swap-
ped around after the telephone book has been transferred.
This is where you are able to search for entries. State an initial letter,
and with the voice command “
SELECT
”, all of the entries are read out
which begin with the corresponding letter. You can navigate through
the list by using the commands “
NEXT
” or “
PREVIOUS
”.
Phone book
Playback
Play list
Dial Joe Bloggs
Dial fast search
Select
