5
R
2 GETTING STARTED
2.1 Fitting a battery
Your Elcometer 7410 Concrete Moisture Meter is
powered by a single 9 V battery. The battery is
located in a battery compartment at the rear of
the instrument.
To fit the battery:
1. Using a small screwdriver, coin or key,
push back the tab of the battery
compartment cover. The cover will then lift
away.
2. Fit the battery taking care to ensure correct
polarity.
3. Replace the battery compartment cover.
When the battery is nearing the end of its useful
life both lights on the front of the gauge flash for
3 seconds whenever the gauge is switched on.
The battery must be replaced when this happens.
7410_TMA_0354_Issue_03.fm(19520).fm Page 5 Friday, June 5, 2009 3:08 PM
7410
Concrete Moisture Meter
7 of 17
For more information
/ 1300 287 935
[email protected] / www.burwell.com.au
