BURT MJ12-1600, Инструкция по эксплуатации

Страница: 18 / 36

This machine has the capability of crosscutting
workpieces while using the hold down w/mitre gauge.
5 . Mount the hold down arm onto the stud and lock the
work-piece in place.
6. Once all the necessary safety precautions have been
taken, perform the cutting operation.
Lastly, this machine has the capability of crosscutting
workpieces while using the rip fence as a cut-off gauge.
Crosscutting smaller panels:
1. Mount the crosscut table to the sliding panel.
2. Install the crosscut fence in the rear guide pin holes
and lock it in place.
Note First, drop the crosscut fence into the rear
guide pin hole, turn the "Z"lock plate to align the
fence, then tighten the knurled nut
.
3. Set either flip stop to the desired width-of-cut.
Note If the workpiece extends to the left of the saw
blade more than 1200mm, then the crosscut fence
slide needs to be extended.
Determine which cutting operation will be best suited 4. Load the workpiece onto the table saw.
for the workpiece to be crosscut.
5 . Mount the hold down arm onto the stud and lock the
If you will be crosscutting full size panels, then skip work-piece in place.
ahead to “Crosscutting full size panels.”
6. Once all the necessary safety precautions have been
If you will be crosscutting smaller panels, then skip taken, perform the cutting operation.
ahead to “Crosscutting smaller panels.”
Crosscutting using the hold down:
If you will be crosscutting workpieces using the hold
down, then skip ahead to “Crosscutting using the
1. Mount the hold down onto the sliding panel.
hold down w/mitre gauge.”
2. Load the workpiece onto the table saw. Secure it
using clamp.
If you will be crosscutting workpieces using the rip
fence as a cut-off gauge, then skip ahead to
3. Once all the necessary safety precautions have been
“Crosscutting using the rip fence as a cut-off gauge.”
taken, perform the cutting operation.
Crosscutting using the rip fence as a cut-off gauge:
Crosscutting full size panels:
1. Mount the crosscut table to the sliding panel.
1. Mount the crosscut table to the sliding panel.
2. Install the crosscut fence in the rear guide pin holes
2. Install the crosscut fence in the forward guide pin
and lock it in place.
holes and lock it in place.
Note First, drop the crosscut fence into the rear
Note First, drop the crosscut fence into the forward
guide pin hole, turn the "Z"lock plate to align the
guide pin hole, turn the "Z"lock plate to align the
fence, then tighten the knurled nut
.
fence, then tighten the knurled nut
.
3. Position the rip fence to the desired width-of-cut.
3. Set either flip stop to the desired width-of-cut.
4. Load the workpiece onto the table saw.
Note If the workpiece extends to the left of the saw
blade more than 1200mm, then the crosscut fence
5 . Mount the hold down arm onto the stud and lock the
slide needs to be extended.
work-piece in place.
6. Once all the necessary safety precautions have been
4. Load the workpiece onto the table saw.
taken, perform the cutting operation.
17
Fig 42
Fig 40
Fig 41