BURT MJ12-1600, Инструкция по эксплуатации

Страница: 8 / 36

UNPACKING
Clean Up
The Sliding Panel Saw is shipped from the
The unpainted surfaces are coated with a light oil to
manufacturer in a carefully packed crate. If you
protect them from corrosion during shipment. Remove
discover the machine is damaged after you have
this protective coating with a solvent cleaner or citrus-
signed for delivery, please call Customer Service
based degreaser. To clean thoroughly, some parts may
immediately for advice. When you are completely
need to be removed. For optimum performance from
satisfied with the condition of your shipment, you
your machine, make sure you clean all moving parts or
should inventory its parts.
sliding contact surfaces that are coated. Avoid chlorine-
based solvents as they may damage painted surfaces
The Sliding Panel Saw is a heavy
should they come in contact.
machine. DO NOT over-exert yourself
while unpacking or moving your
machine you will need assistance and
power equipment. Serious personal
Do not use gasoline or other petroleum-based
injury may occur if safe moving
solvents to clean with. They have low flash
methods are not followed.
points which make them extremely flammable. A
risk of explosion and burning exists if these
products are used.
Some metal parts may have sharp edges on
them after they are formed. Please examine
the edges of all metal parts before handling
them. Failure to do so could result in injury.
Many of the solvents commonly used to clean
machinery can be toxic when inhaled or
ingested. Always work in well ventilated areas
far from potential ignition sources when dealing
Piece Inventory
with solvents. Use care when disposing of waste
rags and towels to be sure they do not create fire
After all the parts have been removed from the carton,
or environmental hazards.
you should have:
Main crate
Main saw unit
Cast iron extension table
Steel plate extension table w/support leg
Rear extension table w/support
Swing arm assembly (inside main saw unit)
Cross cut table
Roller, cross cut
Blade guard
2-1/2" dust hose
Dust port
Mitre gauge
Hand wheels (2)
Hardwares
Tools
13-15 mm open head wrench
Arbor wrench
Arbor pin
3, 4, 5, 6 mm "L" wrench
Push stick
(
Some parts are inside the main saw unit
)
Edge shoe
Rail crate
Rip fence
Rip fence rail
Rear support rail
Sliding table
Sliding table carrier
Support leg, sliding carrier
Cross cut fence
Hold down w/fence
Flip stop
7