1
LIST OF FUNCTIONS
Through factory settings a lot of functions are disabled to operate the 100 as a simple Phono preamp. The numerous
options the 100 offers are easily reached and activated.
PLEASE NOTICE:
The owner’s manual describes all functions of the complete equipped 100 Phono preamp. Due to
the fact
that there are different equipment versions, variations concerning your unit are possible.
•
2 balanced Phono inputs, XLR 3pin female
•
1 balanced analog output, XLR 3pin male
•
1 unbalanced analog output, RCA
•
1 digital output from ADC (Analog Digital Converter) including 1 S/P-DIF (RCA) and 1 optical fiber output
(TOSLINK)
•
1 USB plug as digital in- or output
•
1 digital output from USB input including 1 S/P-DIF (RCA) and 1 optical fiber output (TOSLINK)
•
Input resistance for MC module or input capacitance for MM module selectable
•
Selectable subsonic filter
•
Automatic channel calibration (AUTO ADJUST) selectable, if the channels of the pickup system have different
sound levels - compensation is possible up to 6dB difference between the channels
•
Selectable volume control for direct use with power amps or active loudspeakers
•
Increasing of output level to +6dB possible for operating the preamp with amplifiers with low input sensitivity
•
180° phase reversal of the balanced output selectable by a DIP-switch on the back panel
•
Selectable ADC (Analog Digital Converter)
•
Sample rate of the ADC selectable between 48kHz/24bit, 96kHz/24bit, 192kHz/24bit
•
Load display of the ADC with analog audio level meter
•
Fast responding overflow LED for short peak distortion of the ADC
•
DC coupled signal path assures best sound reproduction without any phase shift in the audible frequency
range
•
Analog output stages with X-AMP 2 stages
•
Internal BURMESTER GREEN power supply with automatic mains voltage detection
•
Remote power up of other devices possible by means of DC IN/OUT connection
•
BURLINK-module for external control via RS232 or USB
