Burley R1510A, Быстрый старт

Страница: 5 / 8

04
> Make sure that the power supply corresponds with the connection specifications of
the device before it is connected.
> The tool may only be used within the specified limitations for voltage and power (see
type plate).
> Do not touch the mains plug with wet hands! Always pull out the mains plug at the
plug and not by the cable.
> Do not bend, crush, pull or drive over the power cable, protect from sharp edges,oil
and heat.
> Do not lift the device using the cable or use the cable for purposes other than intended.
> Check the plug and cable before each use.
> If the power cable is damaged immediately disconnect the plug. Never use the device
if the power cable is damaged.
> If the device is not in use make sure the plug is pulled out.
> Make sure that the device is switched off before plugging in the mains cable.
> Make sure that the device is switched off before unplugging it.
> Disconnect the power supply before transporting the device.
3.Device-specific safety instructions
> Make sure the workplace is adequately ventilated. Residual gases and vapours can
be harmful to health.
> Do not operate the product in moist environments or allow it to become moist.
> Careless handling of the product increases the risk of fire and explosion.
> Flammable and toxic gases can develop when working with synthetics, paints,
varnishes and similar materials. Do not work in the proximity of highly flammable
gases or materials.
> Heat can reach flammable parts that are not visible.
> Do not use the product in the same position for a long time.
> Risk of burns! Do not touch the hot nozzle. Wear protective gloves.
> Never point the hot air current at persons or animals.
> Never use the product as a hair dryer or for drying clothing.
> Do not move the heating element too close to the part to be treated. The resultant
build up of air can cause the product to overheat.
> Do not block the air inlet openings.
> Let the product completely cool before storing. The heating element can cause
damage and fires.
> Symbols affixed to your tools may not be removed or covered. Information on the
device that is no longer legible must be replaced immediately.