Page 11 of 16
13.
Additional Information
Remote Control Models.
Installation Instructions
NOTE – USE THESE INSTRUCTIONS TOGETHER WITH PUBLISHED DETAILS IN INSTRUCTIONS
ABOVE.
If the fire tray is removed for installation, take care to route any fixing cables and gas supply
pipes away from the workings of the burner tray.
Replace the tray and refit the entire coal layout, glass etc in accordance with the Installation
Instructions.
The fire comes with a special 7.2volt NiMh rechargeable battery, charger, and connection wire.
This is supplied loose with the appliance to prevent inadvertent operation. To operate the
product the battery must be charged using the supplied charger in the kit. The battery will take
between 2 -4 hours to fully charge. In normal use, this will last 1 month before the battery
requires recharging. The charger has indication lights to inform you of its status. (
Actual product
may look different from the pictures featured above)
To attach to the appliance, plug together the multiblock connector on the battery with the
matching connector on the front right hand side of the fire. Then slide the battery into position
underneath the fire in the purpose made battery housing.
Note – If the fire emits a beeping
sound, this is just the safety system priming itself.
Because the remote control uses battery power, when in the stand-by mode. The battery will
need charging on a monthly basis irrespective of use. If the battery is allowed to discharge then it
may not be possible to re charge it.
A handheld remote control is included in the box and this has a 9 volt battery to power it. The
battery should be changed annually to prevent false signalling caused by a partially flat battery.
The battery is accessible through a flip off cover on the back of the handset and the battery
clipped onto the terminals inside.
When disposing of batteries, always do so in an environmentally friendly manner.
Replacement rechargeable batteries for the fire and replacement handsets are available from
Burley Appliances on 01572 756956 or through your retailer. The 9 volt handset battery is
available from normal retail outlets. Please note that the cost is not covered by the guarantee.
Infra red sensor
This is on a retractable holder on the left hand side of the facia. It is also possible to swivel the
holder. Take the fret and ash pan and adjust the sensor position so that it is visible from under
the fret. The handset must have direct line of site to the sensor in order for it to work.
Operating the appliance:
See user’s instructions.
