4
Image 11: Connect ribbon cable and 2 pin
connector, where applicable.
Image 12: 1U vent above B16 chassis allows for proper ventilation.
4. Install Daughter Cards
Important Installation Notes:
1.
Install the 1U vents above the B16 chassis. The MOTHERSHIP MUST run with prop-
er ventilation.
2.
Failure to properly vent the MOTHERSHIP chassis above and below may cause fail-
ure, and will void the warrenty.
5. Attach Ribbon Cables To Faceplate
6. Re-attach Lid With All Screws
7. Install Vent ABOVE B16 Chassis
8. Clocking
The B16-BMB clocks off of Internal Clock, External Word Clock or AES Channels 1/2. For
best results, we recommend clocking off of INT, Internal Clock.
1.
See card slot numbers and corresponding Inputs and Outputs on page 3.
2.
Daughter Cards will ship with wire assemblies already attached to the Daughter
Cards.
3.
Make sure the card is inserted into the card guides and properly connects to the
backplane.
4.
Pull cables through to the front for connection to the faceplate.
