TSE BUSINESS 5000
English |
9
– Fasten the battery compartment lid with screws.
Attention!
Make sure that no moisture enters the
keypad when replacing the battery.
Cleaning instruction
The surface finish of the keypad prevents adherence of impurities. Dust or
dirt can be removed from the surfaces using a damp cloth.
No alcohol-based detergents (spirit, SIDOLIN® etc.) or aggressive detergents
(acetone etc.) may be used, as they can damage the surface or the sensor.
Assembly manual for TSE Cylinder
The installation of the TSE cylinder is described below.
Please read this Assembly Manual carefully before the assembly and then
store it in at a safe place.
The cylinder has a special detent system, offering you a possibility of using
the cylinder for doors with a thickness up to 120 mm (60/60 mm, measured
at the central detent bolt). No prior adjustment is necessary.
Attention:
Be careful to not bang the knob anywhere, as the knob can break in
such case. The lock should not be greased or oiled.
An incorporated locking screw in each knob is to fix the rotary knobs.
Attention: Never pull the inner knob completely from the shaft, as
this might cause damage to the electronics! The locking screw,
which ensures the detent on the shaft, may be loosened only lightly
and it always remains in the plastic knob, providing protection
against pulling it out.
Outer side
Inner side
Outer knob
Inner knob
Cover
Adapter 2
Adapter 1
Detent bolt
Locking screw
for fixation onto
the shaft
Remark
The base size of the cylinder is 30 mm per side. When delivered, the cylinder
is completely collapsed (the smallest door thickness). Before you insert the
cylinder into the door, you should adjust it to your door thickness.
When installing the cylinder, proceed as follows:
1
Take a rough measurement of the door thickness (incl. fittings)
2
Pull the outer knob from the shaft, move the inner knob over the
detent system (spacing 2.85 mm) to the required dimension.
Attention:
Never pull the inner knob completely from the shaft, as this
might cause damage to the electronics!
Inner knob
30 mm ajustment range
Schematic illustration of
setup of the inner knob
ajustement
3
Depending on the door thickness, you can affix an appropriate adapter on
the outer side, in order to improve the path for the emergency key.
The following combinations are possible:
Space detent bolt / fitting
(mm) on the outer side
Adapter 1
Adapter 2
< 43
–
–
44 – 53
X
–
54 – 60
X
X
Tab. 1: Space detent bolt/mounting [mm] on the outer side
and the required adapter
2,<9 × 16
Adapter 2
M2 × 10
Adapter 1
4
Move the TSE cylinder from inside to outside through the mortise lock
into the door and then tighten the detent bolt.
5
Shift the inner knob over the shaft until attaining the required
dimension. Please make sure that the clearance between the rotary
knob and the door mounting is at least 1 mm. Then fix the rotary
knob using the hex key.
