2.4.3 Lighting sequence
Important:
Prior to operation, ensure ALL packing material has been removed from
appliance.
Hotplate
1. Ensure mains gas is turned on.
2.
To light hotplate burners, press knob and turn to full flame position. Ignite burners
using taper or match. Hold in knob for 5 - 10 seconds and then release. Check burner
remains lit and turn knob to required position.
3. To turn the hotplate off, turn knob to OFF position.
Oven
1. Switch on electrical supply at mains. Green neon indicator should illuminate.
2. Turn oven thermostat knob clockwise, the fans should rotate clockwise. Amber neon
indicator will illuminate when setting is higher than actual oven temperature.
3. Thermostat will cycle on/off in order to maintain set temperature.
4. To turn oven off, turn knob to OFF position.
2.5 INSTRUCTION TO USER
Whenever possible, the installer should ensure that the user thoroughly understands the
instructions for lighting, cleaning and correct use of the appliance.
It is also important to ensure that the location of the gas isolating cock is made known to
the user, and that the procedure in an emergency is demonstrated.
SECTION 3 - SERVICING
IMPORTANT:
BEFORE ATTEMPTING ANY SERVICING, ENSURE ISOLATING COCK IS
TURNED OFF AND CANNOT BE INADVERTENTLY TURNED ON, AND ISOLATE THE
ELECTRICAL SUPPLY.
AFTER ANY MAINTENANCE TASK, CHECK APPLIANCE TO ENSURE THAT IT
PERFORMS CORRECTLY AND CARRY OUT ANY NECESSARY ADJUSTMENTS AS
DETAILED IN SECTION 1.
After carrying out any servicing or exchange of gas carrying components
ALWAYS
CHECK FOR GAS TIGHTNESS!
Electrical wiring diagram is included at the back of this handbook.
3.1 REMOVAL OF CONTROL PANELS AND BURNERS
Various panels are removed as follows:
3.1.1 Removal of fascia panel
1. First remove all control knobs.
2. Open oven doors and remove the two screws from the underside of the fascia panel.
3. Remove the two screws at each end of the fascia panel.
4.
Lastly remove the 3 fixing screws from the front of the fascia panel.
5. Fascia panel can now be removed from the appliance.
3.1.2 Removal of the hotplate
1. Remove all pan supports, burner caps and burner skirts.
2. Using the front left hand and right hand burner apertures lift the front of the hotplate
upwards to an angle of approximately 45° and then pull the hotplate forward.
3. The hotplate should now be free from the rear vent and can be removed from the
appliance.
3.1.3 Replacement of hotplate burner (jet holder)
1. Remove hotplate as detailed on the previous page.
2. Disconnect the hotplate pipe from the chosen burner by undoing the compression nut
at the burner.
3.
Remove the two fixing screws holding the hotplate burner in place.
4. The burner can now be removed from the appliance.
5.
The new hotplate burner is to be fitted in the reverse order.
