Burcam 101059, Руководство по установке, Страница: 3 / 12

3
Information regarding your well may be obtained from your well Driller’s log.
If no information is available, you can determine the depth of the well by lowering a heavy
(small) weight tied to a long cord or fishing line. Lower the weight to the well bottom, take up
the slack, and mark line where it meets the top of the well. Remove the weight from the well
and measure line to determine well depth. Repeat the operation with a dry cord. Mark the
line at the top of the well and where it become wet. You now know where is the water level.
Please remember, a submersible pump should not be lower than 10 feet from the
bottom of the well an no higher than 10 feet below the water level.
If you are replacing your old pump with a new pump of similar horsepower and capacity,
install the new pump at the same level in the well. If a new pump is larger in horsepower (ie :
replacing a 1/2 HP with a 3/4 HP) or if the pumping capacity is higher (ie : providing 7 GPM
instead of 5 GPM), set the pump deeper in the well provided that the well will support the
additional volume.
BEFORE
YOU
START
Material required for a drilled well application
Deep well pump installation

Desired length of polyethylene 1” pipe, 100 PSI,
CSA or UL approved, to link up from pumping level
to pump.

1 Poly rope

Well seal (150156)

Pitless adaptor (150155)

1” Male brass adaptors (750871)

1” Stainless steel clamps (750885)

Teflon tape

Pressure relief valve 1/2’’ NPT

Torque arrestor (150158)
Tools
Screwdrivers, hacksaw to cut pipe, knife to assist in pipe cutting, round file to smooth pipe
ends, pipe wrench, adjustable wrench to tighten fittings, propane torch and welding material.
Tank installation

Desired length of 1” braided hose (750919) to
link up from pump to tank. Keep tank as close as
possible to the pump.

1 Tank ‘‘T’’ (650651)

1 1/2’’ Drain valve (650659)

1 1/2’’ Safety valve (150162)

2 1’’ Female adaptor (750949)

1 1’’ Galvanized or brass elbow

Pressure gauge (750769)

L.O.P. pressure switch (150159S)

1/4’’ X 3’’ Galvanized or brass nipple

Teflon tape
INSTALLATION STEPS