6
Brewer does not
turn on
• Make sure brewer is plugged into a working outlet.
• Press the On/Off Button to begin brew (red light will be illuminated).
Coffee is not
brewing
• Make sure brewer is plugged into a working outlet.
• Make sure brewer is filled with water. A minimum of 4 cups (20oz) is needed
to begin brewing.
• Make sure brewer clock is set.
• Press the On/Off Button to begin brew (red light will be illuminated).
• Check to see if Auto-Start time was programmed accurately.
Brew time is
longer than usual
• Check Sprayhead holes for debris. Clean Sprayhead and perform Brewer
Maintenance, see instructions on page 6.
Brew funnel
overflows
• Be sure Brew Funnel is properly inserted.
• Use BUNN paper filters – they are taller to prevent overflow.
• Be sure Sprayhead is in place.
• If overflow continues, contact BUNN for a Flow Restrictor Sprayhead.
Warmer plate
stays on after
brewing phase
• Warmer plate automatically shuts off after 2 hours. To shut off
manually, push the On/Off Button (red light will turn off).
This unique brewing system is sensitive to mineral
build-up from the water you use.
Therefore, it is
very important to clean the internal system at least
every 3 months or whenever the digital displays
shows “CLEA” after a brew cycle is done. The
higher the mineral content in the water you use, the more often you should clean.
Regular internal system cleaning will prolong the life of your Phase Brew and help guarantee
an optimal brewing result.
1.
Remove the Sprayhead located above
the Brew Funnel by turning with your
fingertips.
2.
Check the Sprayhead. If plugged with
mineral deposits or white flakes, use a
toothpick to remove. Clean the Sprayhead
with a cloth and mild detergent. Rinse the
Sprayhead with water.
3.
Slide empty Brew Funnel into the Funnel
Guides under the Sprayhead.
4.
Open the spin lid on top of the brewer
and fill brewer with water to the 6-cup
(30oz) mark.
5.
Add 2 cups (10oz) of white vinegar to
brewer, filling it to the 8-cup mark.
6.
Close the Spin Lid.
7.
Place empty Carafe on the base Warmer
Plate of brewer.
8.
Press the On/Off Button to cycle the
vinegar solution through the brewer.
9.
Empty carafe at end of cycle.
10.
Run 3 or more additional cycles with full
carafes of water to flush remaining vinegar
solution from the brewer.
11.
Reinstall Sprayhead.
Note:
For a stronger clean, 100% white vinegar (40oz or 8 cups) can be used. Press the
On/Off Button and let the machine heat for 4 minutes. Then press the On/Off Button to
pause the machine. Let the vinegar soak for 30 minutes. Press the On/Off Button to restart
the machine and finish brew cycle. Run 3 or more cycles with full carafes of water to flush
remaining vinegar from brewer.
BREWER MAINTENANCE
h
m
auto
start
clock
on/off
TROUBLESHOOTING
problem
suggestions
