7
TROUBLESHOOTING
continued
problem
suggestions
Programmed
Auto-Start did
not work
• Make sure AM/PM was accurately selected.
• Reprogram for Daylight Savings Time or a power outage if needed.
• Make sure Auto-Start button is illuminated.
Digital display
flashes between
time and ‘CLEA’
• Perform Brewer Maintenance, see instructions on page 6.
Water drips
through prior
to completing
Heating Phase
or before
programmed time
• Lime or mineral build-up may prevent the valve between the Top Tank
and Sprayhead from properly closing. Perform Brewer Maintenance, see
instructions on page 6.
Rumbling noise
• Normal while water is heating.
• Will occur if you pour fresh water into unit immediately after brewing.
• Will occur if you pour fresh water into unit when the warmer is still on from
previous brew.
Off taste is
detected
• Perform Brewer Maintenance, see instructions on page 6.
Water heats but
will not release
• If you are in a high altitude environment (over 4,000 feet), you will need
a model with “D’ designation as the thermostat has been preset for high
altitude environments.
• Perform Brewer Maintenance, see instructions on page 6.
Carafe is leaking
from Pour Spout
• If you have a Carafe with a plastic Pour Spout, it is easy for coffee oils to
build up on the shiny polished area. These coffee oils are difficult to see and
can impact the pour. To clean the Pour Spout, use a small amount of mild
detergent on the polished, shiny area. Use a soft cloth to scrub the shiny
area of the Pour Spout until the film is gone. When finished, thoroughly rinse
carafe and lid with clean water.
www
.
bunnathome
.
com
bunn
-
o
-
matic
corporation
in
the
united
states
:
1400 Stevenson Drive, Springfield, IL 62703
900 E. Townline Rd., Creston, Iowa 50801
1-800-352-BUNN (2866)
in
canada
:
280 Industrial Parkway S., Aurora, Ontario L4G 3T9
1-800-263-2256
To receive full assistance, have the Model and Date Code ready when calling.
Record the Model and Date code before using: The model is located on the lower back of
your brewer. The date code is located on the metal prongs of your power cord - 4 digits
are etched on each side of the metal prongs (Ex. 9999 99CH).
AUTHORIZED SERVICE
