Bunn My Cafe AP, Техническое учебное пособие

Страница: 21 / 34

Bunn-O-Matic Corporation
21
Step 3: Clean pod bin and drip tray.
□ Pull the driptray assembly straight towards you.
□ Pull the bin straight out and empty as required.
□ Separate the parts and wash with a mild, non-abrasive liquid detergent.
Step 4: Clean the stream guide bowl.
□ Access programming and scroll to “Service Tools” menu. Depress the button under yes.
□ Select “Yes” under “Test Outputs” menu and select “Yes” under “Test Index Motor” menu.
□ Use a screwdriver or similar object to hold door open.
□ Press and hold “Dump” (Open/Close) button until pod holder moves back
and clears the stream guide bowl for cleaning.
□ Disconnect brewer from power supply.
□ Insert a small standard blade screwdriver in the seam and pry up to remove
bowl cap.
□ Use clean wash cloth to clean cap and lower stream guide bowl.
□ Insert 26367.0000 cleaning brush from the underside into the coffee outlet
hole (rear) and work back and forth.
□ Reinstall bowl cap by aligning the tab and notch then put back into position.
□ Remove the object holding the door open and return the pod drawer back to home position by exiting program
mode and simply depressing the open/load button a couple of times.
Step 5: Remove the inlet valve connector fitting and clean inlet valve strainer.
□ Using your hand, unscrew the valve adapter fitting and set aside.
□ Using the needle nose pliers, gently grab the strainer tab and pull the strainer out of the valve.
□ Clean and rinse the strainer of any sediment or mineral build-up.
□ Reassembly is the opposite of disassembly.
Inlet Valve Strainer