Page 16
9. Repeat step 10 until the top line is complete.
10. Press and release "DONE". The display should now read "WRITE BTM LINE?".
11. To write the bottom line of the new ad, press and release "YES".
12. To skip the bottom line, press and release "NO".
13. a. If neither a top nor bottom line was written, the display should now read "ENTER SERVICE #?".
b. If only a top line was written, the ad will be displayed followed by "SAVE?" Proceed to step 16.
14. The display will now read A with a flashing cursor below it. Press and hold the "SCROLL" switch
to scroll through the alphabet and available characters. When the desired character is shown on
the display, press and release "NEXT" to move to the next character in the bottom line.
15. Repeat step 14 until the bottom line is complete.
16. Press and release "DONE". The display will now show the written ad, and then "SAVE?"
17. To cancel saving the ad, press and release "NO". The display should now read "ADVERTISEMENT
NOT SAVED!" and then will return to the "NEW AD" screen. To exit programming and return to
the MAIN SCREEN, press and release the "ENABLE BREW ON/OFF" switch.
18. To correct or edit the ad, press and release "EDIT". The display should now read "WRITE TOP
LINE?" Repeat steps 10 though 17.
19. To save the ad as it is shown, press and release "YES". The display should now read "ADVER-
TISEMENT SETUP COMPLETE", and then "ENTER SERVICE #?". To exit programming and
return to the MAIN SCREEN, press and release the "ENABLE BREW ON/OFF" switch.
ENABLE SANITATION
NO DONE YES
Set the time before a cleaning alert will be displayed.
RANGE:
1 to 30 days
Enables the mode function and sets the idle time. Then choose to have the
tank heater(s) turn off, or reduce the tank temp to (140° F) or (60° C) once
the set idle time has expired.
Range:
0.5 to 24.0 hrs
Enabl EnergySavr
NO DONE YES
Adjusts the sensitivity of the refill circuit. Water in different geographical
locations can have different conductivities. Make sure the water in the tank
is touching the refill probe.
NOTE:
Always make sure that the # on the right
is larger than the # on the left when water is contacting the tank refill probe.
0 REFILL 155
(-) DONE (+)
PROGRAMMING (cont.)
48497.2 111017
