Page 4
For technical questions, please call 1-888-866-5797.
Item 64759
Specifications
Lamp
60 SMD LEDs
Battery Pack
3.7 VDC, 1500 mAh Li-Ion Battery
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note:
For additional information regarding the parts listed in the following
pages, refer to
Parts List and Diagram
on page 11.
Installation
1. Decide where to place the Lamp and Solar Panel.
a. The Solar Panel is equipped with a 15 foot long
Solar Power Cable, so the Lamp and Solar
Panel can be installed up to 15 feet apart.
b. The Solar Panel must be set in a location
that receives full, direct sunlight, a minimum
of 8 hours a day. Ideally, the Solar
Panel should be angled slightly toward
the South (northern hemisphere).
2. Mount the
Solar Panel:
a. Place the Solar Panel in the desired location,
adjusting the unit to best fit the surface.
b. Using the Solar Panel’s base as a template,
mark the hole locations to install the
panel. Set the Solar Panel aside.
c. Verify that installation surface has no
hidden utility lines before drilling or driving
screws. Drill holes for the enclosed
mounting Screws and Anchors.
d. Secure Anchors into holes and connect the
Solar Panel in place with the Screws.
3. Mount the
Lamp:
a. Locate the unit 6 to 8 feet above ground on
a solid surface capable of supporting the
Lamp and secure enough so that it will not
move when exposed to vibrations or wind.
The unit must be high enough to allow for
motion detection and light distribution.
b. Using the Mounting Bracket as a
template, mark the hole locations to
install the Lamp. Set Lamp aside.
Mounting
Bracket
c. Verify that installation surface has no hidden
utility lines before drilling or driving screws. Drill
holes for the enclosed Screws and Anchors.
d. Secure Anchors into the holes and connect
the Lamp in place with the Screws.
4. Carefully route the Solar Power Cable from the
Solar Panel to the Lamp and plug it into the Solar
Power Input on the Lamp’s Battery Housing.
5. Adjust the Motion Detector Head by moving it left
or right so that it faces the area where movement
will occur. Move it up or down using the screw
located on the neck of the Motion Detector Head.
SAFETY
OPERA
TION
MAINTENANCE
SETUP
