Bungard StenPrint 3000, Инструкция по эксплуатации

Страница: 12 / 31

13 Instruction manual
© 22.02.2017 Bungard GmbH & Co. KG
4.2.1
Tilt mechanism
The frame fixture is equipped with a tilt mechanism in order to be able to tilt the frame with
the stencil upwards. This is necessary to place the PCB in the stencil printer.
When the tilt mechanism is opened, it clicks into the upper position
A locking knob (3) has to be pulled to close the mechanism.
Tilt m echanis m
Attention
The tilt mechanism must be held open with your other hand whilst pulling the
locking knob to prevent it from falling shut.
4.2.1.1
Adjusting the tilt mechanism
The degree of tilt of the stencil printer's tilt mechanism can be altered by way of an
adjustment screw (5). By doing so, this enables the stencil printer to adapt to various
stencil frames. With frames of varying weights, the tilt mechanism must be adjusted such
that the stencil is positioned parallel to the PCB.
Adjus ting the tilt m echanis m