BB Trainer Revision 3.doc
36
Armed (caution)
Low Batt.
Armed (caution)
Trouble Shooting Guide
Misfire
One or both launch assembles misfired. That is, you
attempted to launch but failed to launch one or both
bumpers.
Did you turn on the transmitter
?
Press the
“ARM/ON”
key.
o
IF the red light under the
“ARM / ON”
key turns on
press and hold the “LAUNCH”
key for two seconds.
If the launch event occurs you probably forgot
to arm the transmitter, or more than 45 seconds
elapsed after you armed the transmitter. Continue
training.
If you observe a
“Low Batt.”
Warning light you will normally
be able to continue training; however, system
performance may become unreliable.
If the launch event fails to occur, proceed with
Troubleshooting the launcher (on the next page).
o
IF the light below the
“ARM / ON“
key fails to turn
on charge the transmitter battery.
Following the recharge, conduct the “In House
test”.
If the test is not successful call Bumper Boy
Customer Service at 1-800-729-3822.
Arm
On
BB Trainer Revision 3.doc
37
Troubleshooting the launcher
Did you turn the receiver on (Receiver toggle to the
right)?
If not, turn it on. You may continue with your training
at this point.
If yes, continue.
Are the firing pins cocked?
If not, you may cock the firing assemblies and
proceed with your training.
If yes, continue.
If the firing pins are cocked and the receiver was on:
Unload the launcher (see page 33, “
Unloading a
Loaded Launcher”
).
Conduct the In House Test and Load Test to
determine if the system is functioning properly.
If the tests are successful, repeat the loading and
firing sequence and proceed with your training.
If the tests are not successful, check all electrical
connections and repeat the tests.
If the tests are still unsuccessful proceed as
follows:
Sound does not work
Complete these steps only after following procedures for
“
Unloading a Loaded Launcher” (page 33).
Check the speaker connection at the receiver. If it is
loose, secure the connector and activate the sound
again.
