6
…pic 5…
(Recirculation Coolant System)
4 UNPACKING
Remove packing materials and lift out machine complete with baseboard. Remove 4
securing bolts that secures machine to baseboard
4.1 Installation
Open cover
Remove the shipping strap from the cutting head and push the cutting lever to the rear to raise the cutting
Wheel as high as possible.
Install the cutter on suitable table and secure alignment by means of adjusting positions of 4 secure
leveling bolts.
Plug to mains 380-400V (3 phase) power and check the turning position of cutter and ensure correct
turning if necessary.
4.2 Installation Commissioning
Check the machine's electrical connection is made before the electrical diagram. The machine needed to
make the detection of the voltage and frequency. After making this determination, the machine outlet is
provided in a suitable location with Make a connection to the required fixing. Under normal conditions, the
machine380-400V / 50-60Hz (3P + N + GND) to work with. Make sure the grounding.
IMPORTANT: Electrical connection is made, then check the rotational direction of cooling the engine and
cut the engine and changing the location of phase reversal Provide status 2. IMPORTANT: All electrical
work and electrical maintenance, repair and so on. By competent and qualified electrician to make your jobs.
4.3 Plumbing
Locate recirculation pump on its table and bring it to the near of cutter.
Make recirculation pump electrical connections Connect 18 mm coolant supply hose to the rear of cutter
and tighten the hose clamp. Locate the other end to recirculation pump and tighten the hose clamp.
Connect the 40 mm dia coolant return hose to rear of cutter and clip the hose clamp. Locate other end of
hose on filter of reservoir tank.
Fill the reservoir tank with water (55 liter) and %5 (2 liter) of cutting fluid. Locate top cover on tank.
Open the cover of cutter and press PUMP button and allow pump to run a few minutes. This procedure
ensures adequate mixing of coolant solution. (PUMP button is not used when the cover is closed.)
COOLANT
RESERVOIR TANK
TOP
COVER
RECIRCULATION PUMP
FILTER
WATER HOSE INLET
(COOLANT HOSE
FROM PUMP)
FILL THE RESERVOIR TANK WITH WATER (55
LITER) AND %5 (2 LITER) OF CUTTING FLUID.
LOCATE TOP COVER ON TANK.
WATER HOSE EXIT
(COOLANT HOSE TO RESERVOIR)
LEVELING BOLT
