DOC. # 40465B-99 V1.0
(940) 783-9915 | WWW.BULLYDOG.COM
SECTION 7:
CUSTOMIZING YOUR MONITORING EXPERIENCE
SECTION 8:
DIAGNOSTICS
SECTION 10:
CUMMINS UNLOCK
SECTION 9:
SETTINGS
SETTINGS > GENERAL
1.
START GAUGES AFTER POWER ON
device
will boot to the gauge screen.
2.
USER SETTINGS RESET
Removes all user
settings including brightness and saved
WiFi information.
3.
FACTORY RESET
Returns device to factory
settings and removes all data from device.
1. Locate your Cummins Unlock cable.
2. Locate and disconnect the OEM 3-plug
connector on the back side of the intake
charge tube going to the manifold (on the
driver's side).
3. Plug Bully Dog Unlock Cable into OEM
3- Plug Connector.
4. Route other end of Unlock Cable 3-Plug
Connector from engine bay into cab through
driver's window. Do NOT run through firewall.
5. Connect Unlock Cable 3 Plug connector to Mini
USB port on HDMI Cable.
6. Plug OBDII/HDMI Cable into OEM OBDII port
located under dash.
7. Connect OBDII/HDMI Cable into VIM.
8. Power on GTX Watchdog.
9. Select
CUMMINS UNLOCK
from home
screen and follow on-screen instructions.
Tap anywhere on the screen to edit the configurable layout.
Double tap to customize a specific gauge.
READ DTCs:
1. Select
DIAGNOSTICS
from the home screen.
2. Select
READ DTCS
from the menu.
3. Ensure the vehicle key is in the on position.
4. The device will display any DTCs available.
5. Select a DTC for more information.
CLEAR DTCs:
1. After selecting
DIAGNOSTICS
from home
screen, tap
CLEAR DTCs
.
LAYOUT
Change the layout of the current
gauge screen.
DATA
Select the gauge data.
BRIGHTNESS
Change the screen brightness, activate the
light sensor and select day/night themes.
UNIT
Select the unit of display for
this data.
RESET
Reset maximum and minimum observed
data values.
RANGE
Set the display range for the
selected data.
RECORD
Record datalog for playback using Bully
Dog LiveLink Software.
ALERT
Set visual and audio alerts.
DATASET
Select which set of vehicle data or DLX
you would like to monitor.
Barometric Pressure
85
87
1
11
672
2276
-10
4.8
0
2.11
11.36
14.36
86.0
Boost
2.02
Control Module Voltage
14.17
Engine Fuel Rate
11
Engine RPM
2185
Fuel Injection Timing
4.4
BRIGHTNESS
RESET
RECORD
DATASET
LAYOUT
READ DTC
EXIT
CONTINUE
TURN KEY ON
Turn the vehicle’s ignition key to the
ON position or push & hold the
Engine Start Button for 2-3 seconds.
DO NOT START the engine.
READ DTC
EXIT
CLEAR DTCs
PO452
PO463
PO57C
PO625
EVAP SYSTEM PRESSURE SENSOR/SWITCH CIRCUIT LOW
STARTER RELAY A CIRCUIT
FUEL LEVEL SENSOR CIRCUIT HIGH
NO ADDITIONAL INFO AVAILABLE
GENERAL SETTINGS
START GAUGES AFTER POWER ON
USER SETTINGS RESET
FACTORY RESET
USER RESET
RESET
ON
Boost
Control module Voltage
Engine Fuel Rate
Engine RPM
MIN 0.00
MAX 14
UNIT KPA
ALERT OFF
BOOST
UNIT
RANGE
ALERT
DATA
LO
CK
A
CC ON S
TA
RT
