Bulls BROSE FIT, Руководство по эксплуатации

Страница: 212 / 290

MY22XXX - XX_1.0_14.06.2022
211
Inspection and maintenance
8.5.7 Inspecting axle with quick release
1 Undo quick release.
2 Fasten quick release.
3 Check the position and clamping force of the
quick release lever.
 The quick release lever is flush with the lower
housing.
 You should be able to see slight impression on
the palm of your hand when you close the quick
release lever.
Figure 193: Adjusting the quick release clamping force
4 Use a 4 mm hexagon socket spanner to adjust
the clamping lever clamping force if required.
5 Check the quick release lever position and
clamping force again.
Figure 194: Adjusting the quick release clamping force
Crash caused by unfastened quick
release
A faulty or incorrectly installed quick release may
become caught in the brake disc and block the
wheel. This will cause a crash.
 Install the front wheel quick release lever on
the opposite side to the brake disc.
Crash caused by faulty or incorrectly
installed quick release
The brake disc becomes very hot during
operation. Parts of the quick release may become
damaged as a result. The quick release comes
loose. This will cause a crash with injuries.
 The front wheel quick release lever and the
brake disc must be situated on opposite sides.
Crash caused by incorrectly set clamping
force
Excessively high clamping force will damage the
quick release and cause it to lose its function.
Insufficient clamping force will cause a
detrimental transmission of force. The
suspension fork or the frame may break. This will
cause a crash with serious injuries.
 Never fasten a quick release using a tool (e.g.
hammer or pliers).
 Only use the clamping lever with the specified
set clamping force.
CAUTION
!