Bullet Barbecue 0-4078, Инструкции по сборке и эксплуатации

Страница: 4 / 19

WARNING: Gas valves are preset at the factory to operate on LP or natural gas. If you wish to convert, be sure to contact your grill
dealer FIRST!
SAFETY !
BEWARE OF SPIDERS
CAUTION:
BURNER TUBES MUST BE INSPECTED AND CLEANED BEFORE FIRST USE.
Spiders and small insects occasionally spin webs or make nests in the burner tubes during warehousing and transit. These webs
can
lead to a gas flow obstruction, which could result in a fire in and around the burner tubes. This type of fire is known as
“FLASH-BACK” and can cause serious damage to your grill and create an unsafe operating condition for the user. Although an
obstructed burner tube is not the only cause of “FLASH BACK’ it is the most common cause, and frequent inspection and cleaning
of the burner tubes is necessary.
3
INSTALLATION INSTRUCTIONS
PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLING YOUR GAS GRILL
Your Built-in Gas Grill comes to you fully assembled. We strongly recommend professional installation and hookup of the Gas
BBQ grill. These instructions will provide you with the measurements necessary for you or your builder to construct a masonry
structure to house your outdoor gas grill.
NOTE TO INSTALLER: Leave these instructions with the consumer for future reference . Your grill must be installed in
accordance with all local building codes.
SPECIFICATIONS FOR BARBECUE STRUCTURE
1. Masonry of your choice can be used for cabinet construction for the built-in gas grill. It must be non- combustible material.
Keep in mind when choosing a location for your grill that it should NOT be located under any overhead combustible
construction. Upper and ground level vents must be provided for combustion air on both sides of built-in cabinet. Vents on
BBQ bowl must remain unobstructed to allow for combustion air.
2. The BBQ Grill requires a wall opening of the following dimensions: See PAGE 5 & 6 for different models
3. Place gas grill assembly into wall opening as shown in illustration on pages 5 and 6. BBQ rests on side and back edges of
BBQ bowl.
4. For Propane Gas LP TANK STORAGE AREA MUST BE ISOLATED FROM GRILL AND VENTED.
5. Do not use any combustible materials for this construction. Minimum horizontal clearance to adjacent combustible surface
from side and back of the grill must be 21 inches.
CONNECTING TO GAS SOURCE
Refer to the following instructions and illustrations for typical gas supply connections. We strongly suggest professional installation
and hook-up of the Gas BBQ.
IMPORTANT: Before connecting grill to gas source, make sure BBQ Grill control knobs are in “OFF” position.
NATURAL GAS CONNECTIONS
Pipe sealing compound or pipe thread tape of the type resistant to the