Bullet Barbecue 0-4078, Инструкции по сборке и эксплуатации

Страница: 14 / 19

1. Remove burners from grill by carefully lifting each burner up and away from gas valve orifice.
2.
Wire brush entire outer surface of burner to remove food residue and dirt. Clean any clogged ports with a stiff wire such as
an open paper clip.
3. Inspect the burner for damage (cracks or holes) and if such damage is found, order and install a new burner.
4. After installation, check to insure that gas valve orifices are correctly placed inside ends of burner tubes. Also check position
of spark electrode.
CLEANING THE GREASE TRAY
The grease tray should be emptied and wiped down periodically and washed in a mild detergent and warm water solution.
ANNUAL CLEANING OF GRILL HOUSING
Burn-off the grill after every cookout will keep it ready for instant use, however, once a year you should give the entire grill a
thorough cleaning to keep it in top operating condition.
1. Shut off gas supply at source and disconnects fuel line from gas valve manifold. Protect fuel line fitting.
2. Remove and clean (as explained before) the cooking grids, flame tamers and burners.
3. Remove warming rack and wash with mild detergent and warm water.
4. Cover the gas valve orifices with a piece of aluminum foil.
5. Brush the inside and bottom of the grill with a stiff wire brush, and wash down with a mild soap and warm water solution.
Rinse thoroughly and let dry.
6. Remove aluminum foil from orifices and check orifices for obstruction.
7. Check electrode as instructed on page 7.
8. Replace flame tamers, cooking grids, and warming rack.
9
. Reconnect to gas source and observe burner flame for correct operation.
IMPORTANT : You should NOT line the bottom of the grill housing with aluminum foil, sand or any other grease absorbent
substance. Grease will not be able to drip down into grease collector and a grease fire could occur.
12
TROUBLESHOOTING
If grill fails to operate properly
1. Turn off gas at source, turn control knobs to “OFF”, and wait five minutes before trying again
2. Check gas supply/connections.
3. Repeat lighting procedure and, if grill still fails to operate properly,
TURN “OFF” GAS AT SOURCE, TURN CONTROL
KNOBS TO “OFF” , wait for grill to cool, and check the following:
a.
Misalignment of burner tube(s) over orifice(s)
CORRECTION: Reposition burner tube to properly seat over orifice.
b.
Obstruction in gas line