Bull NovaScale Blade B260+, Инструкция по установке и эксплуатации

Страница: 48 / 74

34
NovaScale Blade B260+ - Installation and User's Guide
6. Turn on the blade server (see Turning on the blade server on page 9 ).
7. For certain options, run the blade server Configuration/Setup Utility program (see
Chapter 4 , Configuring the blade server , on page 39 ).
Note:
If you have just connected the power cords of the Blade Chassis to electrical outlets, you
must wait until the power-on LED on the blade server flashes slowly before you press the
power-control button.
3.15.1 Installing the blade server bezel assembly
The following illustration shows how to install the bezel assembly.
Figure 3-17. Installing the bezel assembly
To install the blade server bezel assembly, complete the following steps:
1. Read the safety information that begins on page v and “ Installation guidelines ” on
page 13 .
2. Connect the control-panel cable to the control-panel connector on the system board.
3. Carefully slide the bezel assembly onto the blade server until it clicks into place.
3.15.2 Closing the blade server cover
Attention:
You cannot insert the blade server into the Blade Chassis until the cover is installed
and closed or an expansion unit is installed. Do not attempt to override this
protection.
The following illustration shows how to close the blade server cover.