Bull NovaScale Blade B260+, Инструкция по установке и эксплуатации

Страница: 37 / 74

Chapter 3. Installing Options
23
Figure 3-9. Lifting the DIMM baffle
7. Locate the DIMM connectors (see the illustrations in “Blade server connectors” on page
12). Determine the connectors into which you will install the DIMMs.
8. Touch the static-protective package that contains the DIMM to any unpainted metal
surface on the Blade Chassis or any unpainted metal surface on any other grounded
rack component in the rack in which you are installing the DIMM for at least 2
seconds; then, remove the DIMM from its package.
9. To install the DIMMs, repeat the following steps for each DIMM that you install:
Attention:
To avoid breaking the DIMM retaining clips or damaging the DIMM connectors,
handle the clips gently.
a. Make sure that both of the connector retaining clips are in the fully open position.
Note:
DIMMs installed in to sockets DIMM1 through DIMM4 align differently from DIMMs
installed in to sockets DIMM 5 through DIMM 8.
b. Turn the DIMM so that the DIMM keys align correctly with the connector on the
system board.
c. Make sure that the small tabs on the retaining clips are in the notches on the
DIMM. If there is a gap between the DIMM and the retaining clips, the DIMM has
not been correctly installed. Press the DIMM firmly into the connector, and then
press the retaining clips toward the DIMM until the tabs are fully seated. When
the DIMM is correctly installed, the retaining clips are parallel to the sides of the
DIMM.
Important:
If there is a gap between the DIMM and the retaining clips, the DIMM has not been
correctly installed. In this case, open the retaining clips and remove the DIMM; then,
reinsert the DIMM.