Bull NovaScale Blade 2320, Инструкция по установке и эксплуатации

Страница: 43 / 114

NovaScale Blade 2320 Installation and User’s Guide 31
Note: If you have just connected the power cords of the NovaScale Blade Chassis to
electrical outlets, you must wait until the power-on LED on the blade server
flashes slowly before pressing the power-control button.
Installing the NovaScale Blade 2320 Server Bezel Assembly
See the illustration in “Removing the NovaScale Blade 2320 Server Bezel Assembly” on
page 19 for information about installing the bezel assembly.
To install the blade server bezel assembly, complete the following steps:
1. Read the safety information beginning on page 61 in Appendix B, “Safety
Information” and “Installation Guidelines” on page 15.
2. Connect the control-panel cable to the control-panel connector on the system board.
3. Carefully slide the bezel assembly onto the blade server until it clicks into place.
Closing the NovaScale Blade 2320 Server Cover
Important: The blade server cannot be inserted into the NovaScale Blade Chassis until the cover is
installed and closed or an expansion unit is installed. Do not attempt to override this
protection.
The following illustration shows how to close the blade server cover.
To close the blade server cover, complete the following steps:
1. Read the safety information beginning on page 61 in Appendix B, “Safety
Information” and “Installation Guidelines” on page 15.
2. If you removed the blade bezel assembly, replace it now (see “Installing the
NovaScale Blade 2320 Server Bezel Assembly” on page 31 for instructions).
3. Lower the cover so that the slots at the rear slide down onto the pins at the rear of the
blade server, as shown in the illustration. Before closing the cover, check that all
components are installed and seated correctly and that you have not left loose tools or
parts inside the blade server.
AF000437
Blade-Cover
Release
Cover
Pins
Blade-Cover
Release