Bull Escala, Инструкция по установке и настройке, Страница: 19 / 36

3-1 Software Installation and Configuration
Chapter 3. Software Installation and Configuration
Once the modem is physically present in your machine and connected, you must:
–
Check the Software Pre-load
–
Check, or perform, the configuration of your modem, depending on whether or not it
was integrated in your system delivery.
You will find information in:
•
How to Check Software Pre-load
•
How to Configure the Modem
•
How to Check the Modem Configuration
•
De-installation of the Internal Modem
How to Check Software Pre-load
Use the SMIT interface to check that the ISA Internal Modem LPP has been pre-loaded on
your system:
•
Logged as ’root’ user, type:
# smit lslpp_installed
and select from the list the two OPPs of the ISA Internal Modem:
–
devices.isa.bullmodem2834I.diag
–
devices.isa.bullmodem2834I.rte
You can also check the software installation with the
lslpp
command (
lslpp –l |grep
bullmodem)
.
If you are not familiar with the AIX installation procedure, refer to the
AIX Installation
Guide
for more information.
Note:
If it were not preloaded, you would have to use the Bull-Enhancement CD-ROM,
run:
’smit install_latest’
, select the OPPs mentioned above and finally run
’smit ttyadapters’ so that the system takes into account this new device.