Page 3 of 6
Model: CD1007, LED Blinker Conversion Kit
Installation Instructions:
Disclaimer:
Under no circumstances will Bulbsthatlast4ever or it's representatives be responsible or liable for any incidental or consequential property
damages or personal injuries arising from or in connection with the use or installation of any of the listed foregoing products or devices. Rev. 6/10
Figure 4
4.
Install the screws into the lens, then place an o-ring over each screw, as illustrated in Figure 4 (left & right). The
o-rings will prevent the LED Board from moving around due to vibration.
Figure 5
5.
Firmly seat the LED Board into the signal housing, as illustrated in Figure 5 (left). Then install the lens and
tighten the screws to secure the lens to complete the conversion, as illustrated in Figure 5 (right). Repeat the
above process as needed until for all the blinker assemblies have been converted.
How to Use the Running Light Feature of the CD1007s:
Note: If you desire to use the Running Light Feature, the LED Boards must be wired as described below, (Check
with your local laws regarding amber rear running lights before using this option for the rear lighting):
Decide which configuration shown in diagram Figure 6 is desired, and then construct an external wiring harness
for that desired configuration. Once you have completed constructing of your harness, then connect a wire to
each LED Board from the harness. Refer to Figure 3 (left) for the location of where the wire should be installed
on the LED Board. It is highly recommended that the power source is connected through a 1.0A fuse, which is
switched and only active when the ignition switch is turned on. Secure your harness to the existing main harness
Содержание CD1007
Страница 1: ......
