Bukh DV10, Руководство по ремонту

Страница: 258 / 306

R14
009W2229-R01
Dismantling of Input Shaft
Squeeze off the tapered roller bearing
inner collar.
Dismantling of Lower Gearbox Half
Pull out the tapered roller bearing outer collars
of the lower gearbox with an inner puller
No. 1 x 56 122 208 and auxiliary tool
No. 1 x 56 122 227 and take up the washers.
At the fitting the tapered roller bearing outer
collars have been smeared with Loctite 601
and so heating may be necessary.
At the dismantling: Mark the adjusting washer(s)
which lie below the bearing rings in proportion to
the bore.
Dismantling of Upper Gearbox Half
Pull off the tapered roller bearings outer collars
as described under picture No. 16 above.
Loosen the nuts at the wheel and press out the
bolt of the housing.
Remove slotted pin and washer.