7
Specific safety instructions for cordless drill
Only plug the Battery Charger in 230V mains. Recharge the Battery only with the provided
charger.
Use power tools only with specifically designated battery packs.
When battery pack is not in use, keep it away from other metal objects, lie paperclips, coins,
keys, nails, screws or other small metal objects, that can make a connection from one
terminal to another. Shorting the battery terminals together may cause burns or a fire.
When drilling walls or ceilings be sure that there are no hidden cables. You should not touch
the metal parts of the tool and operate the tool only by holding the plastic housing.
Do not touch the bit after operation. It could be very hot.
Battery and charger safety features.
Over Charging Protection
:this will ensure that the battery is never overcharged.When the
battery has reached its full charge capacity, the charger will shut off, protecting the internal
components of the battery from being damaged.
Over Discharge Protection:
an internal component of the battery pack is an over discharge
protector. This feature will stop the battery from discharging beyond the recommended
lowest safety voltage.
Over Heat Protection:
The battery has an internal Thermister cut off censor which will cease
the charging cycle if the battery becomes hot during the charging process. This Thermister
censor will also stop the battery from operating should the battery become too hot during the
operation of the tool. This can happen when the tool is overloaded or being used for
extended periods of time.Up to 30 min. in cooling time may be required depending on
ambient temperature and operation being performed.
Over Current Protection:
Should the battery be overloaded and the maximum current draw
be exceeded,the battery will temporarily stop working to protect the internal components. The
battery will resume to normal operation once the excessive current draw has returned to
normal safe level.This may take a few seconds.
Short Circuit Protection:
If the battery pack was to short circuit the short circuit protector
would immediately stop the battery pack form operating.This will ensure that no further
internal components of the battery or the tools are
damaged.
Description
1. Keyless Chuck
2. Torque adjustment collar
3. Speed range switch
4. Forward /reverse selector
5. Battery
6. Battery release buttons
7. Variable speed trigger
8. LED light
9. Battery monitor
Application
The power tool is intended for screwing and
drilling through wood, metal, plastics , masonry and stone. IT IS NOT DESIGNED FOR
PROFFESIONAL USE.
Assembly
Disconnect the power plug before carrying out any adjustments or maintenance.
