Building 36 H200BRA, Руководство по эксплуатации продукта

Страница: 4 / 8

2 | Hub Product Manual
Installation
Step 1: Install the Hub
1. Plug one end of the Ethernet cable into the
LAN port on the Hub. Plug the other end of the
Ethernet cable into the network router.
2. Plug in the power supply to the DC IN port on
the Hub.
• Indicator lights will initially flash and rotate
colors during the first few seconds. Wait
until only the White light stays solid or
continues flashing.
• The Hub will then take up to five minutes to
register with Building 36 servers.
TIP: During this time, install each Z-Wave
device around the home.
Step 2: Including Z-Wave Devices
(adding them to the network)
To include Z-Wave devices, each device must be
within direct communication range of the Hub. For
best results, we recommend having the Hub in the
same room as the device you are Including.
1. If necessary, unplug the Hub to move it into
direct range of the first Z-Wave device. Provide
the Hub with power and wait until only a
White Light stays solid or starts flashing.
It is OK
to disconnect the Ethernet cable during the
Inclusion/Exclusion process.
2. Add Z-Wave Devices
• Press Pairing button ( ) on the Hub once to
put the Hub in Inclusion mode. The light will
start flashing Green.
• Follow the Z-Wave device’s instructions to put
the device into Inclusion mode.
Most devices
have an Include/Exclude button.
• Wait for the flashing Green light to stay solid
for 5 seconds to indicated the device has been
successfully included.
An online account is required prior to installing
your Hub. If you do not have an account,
contact your Building 36 Professional Partner to
create one for you.