1 / 2
Remote Control with Standby
Functions and Digital Display
ON/OFF
1. "ON/OFF" key only functions as a switch of the light.
2. If press this button to turn off the lamp before it's short-circuited, the lamp
will remain off after power-on again.
WM/PIR
Change from the microwave sensor function to PIR sensor function, and
the other around.
Scene
Press “Reset” button, products with DIP switch will be controlled by DIP switches;
otherwise all the setting will be just initial, that is 100% detection range,hold time 5S,
no stand-by time and daylight threshold disabled.
Start
Press the button before choosing the parameters.
Memory
Press the button after choosing all the parameters to save them.
Apply
Press the button to deliver the saved settings to the other sensors directly.
Hold Time
The period of light keeping 100% brightness after moving objects leave the detection
area.
Stand-by Period
The period of light keeping low output before it gets completely off. When it's preset
as --, the light always keep at low output even no movement in the detection area.
Power %
Press the button to change the output power from 0% to 100%, it changes 5% every
press.
Test (2s)
The button “Test (2s)” is for testing purpose after commissioning.Pressing this button,
the sensor goes to test mode (hold time is only 2s ).
Increase or decrease theparameters.
Daylight Threshold
Definition of the ambient brightness; only when the ambient brightness is lower than
the preset specific lux amount, the sensor will work; when it's preset as "disable", the
sensor works everytime it detects motion regardless of the ambient lux level.
Stand-by Dimming Level
The definition of low output during the standby period.
SKU: 78-20178-A
Detection Rarea
The area in which movement will trigger the sensor, 100% detection area also means
strong sensitivity.
+
－
Add: 79 Emjay Blvd. Brentwood New York USA 11717
Tel: 516-2185599 / E-mail: [email protected]
Web: www.builderspack.com
SIMPLY RELIABLE
