BÜHLMANN ZHL-16C GF, Руководство пользователя

Страница: 106 / 127

106
8.1.2.4 Dive Planner – NTX DIVE PLAN.
Planner is a module that calculates decompression stops, based on a decompression
algorithm, using data from the gas mix table. Before using the planner, it is necessary to
correctly configure the gas table as it is used by the algorithm to select the optimum gas
mix at the given depth, at the particular moment of the decompression process. Gas mix
selection is automatic (only active gases in the table - "act").
Before planning, you need to set the following
parameters:
Depth – depth of a dive
Time – bottom time
For information purposes, the input parameters of the decompression algorithm are
shown:
Start CNS – initial central nervous system load
Last stop – depth of the last decompression stop
Low GF – value of the "low" gradient factor (at maximum depth)
High GF – value of the "high" gradient factor (near the surface). The gradient factor
values for the intermediate depths are calculated on an ongoing basis by the
controller
Gas – name of currently selected gas. To change the gas, select its name (using the
SELECT button) and then select the new gas (CONFIRM button). Gas is
selected cyclically from the list of active gases (gas configuration table).