Bühler technologies Nivotemp NT M-XP Series, Инструкция по установке и эксплуатации

Страница: 42 / 59

Bedienungs- und Installationsanleitung
Installation- and Operation Instruction
Nivotemp NT M-XP
42
BX100023, 02/2011 Art. Nr. 90 32 040
4.7.4 Switching Output x: Delay for Set Point
Menu
Extended Functions EF1
provides further settings for switching output 1. The menu is located on
the second sub-menu level.
The delay time for set point and reset point avoids too many false alarms in case of fluctuating conditions.
The delay for the set point is set in the following menu:
Extenden functions
EF X
Delay for OUTX on
Delay SP X Parameter
Settings OUTX
Out X ► ► ►
Main menu meas. value
Meas. value ►
Time in seconds which the signal must at least remain to enable the switch to
operate.
Range:
0…100 seconds
Note:
-
If the output characteristic is set to
Window
the value represents the time
delay for the signal remaining within the measurement window.
-
If the output characteristic is set to
Frequency Output
, this value has no
effect.
4.7.5 Switching Output x: Delay for Reset Point
The delay for the set point is set in the following menu:
Delay for OUTX off
Delay RP X Parameter
Extenden functions
EF X
Settings OUTX
Out X ► ► ►
Main menu meas. value
Meas. value ►
Delay for reset point OUT x
Time in seconds which the signal must at least remain to enable the switch to
operate.
Range:
0…100 seconds
Note:
-
If the output characteristic is set to
Window
the value represents the time
delay for the signal leaving the measurement window.
-
If the output characteristic is set to
Frequency Output
, this value has no
effect.