1.
Lay front legs (labeled "O" and "X") on the floor with the brackets
facing upward and inward as illustrated. Note: legs,when placed
on the floor should bend upward, off the floor at their top end and
the width of the unit should remain constant all the way to the top.
2.
Slide each shelf over the brackets of the legs.The top shelf has
the buhl decal on it. The larger shelves are on the bottom. The
shelf with wire hole is the middle shelf. Please make sure the
locking mechanism facing the same direction on middle and
bottom shelves.
3.
Slide the two remaining legs onto the shelves as illustrated.
Make sure that the brackets are on the inside of the shelves.
4.
HAND TIGHTEN
the top, middle and bottom shelves at the two
corners on top with square bolt, washer and nut (see screw table
I) as illustrated. Please make sure washer and nut are together
on the inside of the leg bracket.
5.
In order to have the unit
properly aligned, stand
unit upright on a level
surface. Gently rock unit
back and forth to realign
and level the unit.
TIGHTEN ALL NUTS AND
BOLTS WITH WRENCHES
AT THIS TIME. Unit should
now be properly aligned
and level. If unit is not level
at this time, repeat the
above steps before
proceeding to step 6.
6.
Slide the back panel between the middle and bottom shelf. The
bottom of the back panel needs to hook onto the bottom frame
lip and the top of the panel needs to go in between middle shelf
lip and the brackets.
7.
Lay unit on floor. Insert
casters with brakes
into opposite corner
holes on the bottom of
the unit as shown.
Insert the other casters
into the remaining
holes.
8.
To secure the cabinet panel, use the machine screws(see screw
table K) to tighten the cabinet panels to the frame poles as shown.
There are three screws on each side.
( Instructions continued on next page )
Page 2
